EKey Fingerscan Access Control System Betriebsanleitung PDF herunterladen (Seite 16)

General

„E2“-Error code

30min lock after the security code has been entered

incorrectly three times. Wait 30 minutes before

entering the security code again

„E3“-Error code

Devices connected incorrectly. Connect the devices

again, as one of the devices has been manipulated.

Display

a number between

“1” and “99

” and the dot on

the right is lit up.

Shows the user number of the recognized fingerprint.

Control panel counts down

from „44“ to „0“

State when connected to live current, with no

connection having been created to the finger scanner.

If the control panel does not switch to normal mode

after a few seconds, but continues to

count down, the

physical connection (cable) with the finger scanner is

not intact and has to be checked / corrected.

8.2.1.4

INITIALIZING THE DEVICES

CAUTION! The electrical connection of the system can only be carried out by a specialist!!!

Before you connect the systems to the mains, make sure that both the mounting and the wiring

have been done correctly.

You may only manipulate the electric connections after having separated the system from the

mains!

You will find mounting and wiring instructions in sections 7.4 and 7.5.

CONNECTION BETWEEN CONTROL PANEL AND FINGER SCANNER

When the devices are connected to the power supply, the control panel display starts to count down until

a connection has been created with the finger scanner. Afterwards two red dots appear. During this time

the status display on the finger scanner lights up red. Once the boot procedure has been completed, the

status display begins to flash orange. Now the initialization can be started.

If the counter does not stop on the control panel and you are not taken to the language settings,

please double check the RS485 bus connection (clamp 1 and 2). Alternatively, please check

whether the finger scanner is properly powered (LED blinking or illuminated).

1.)

Press the OK button

2.)

Press the ESC button. "EF" appears on the display, which stands for "Enroll Finger".

3.)

A) Initialization after having replaced the control panel

If it was necessary to replace the control panel because it was defective, then fingers had

already been recorded in the ekey home finger scanner. In order not to have them deleted, a

pre-recorded finger may now be swiped over the sensor, and the initialization process is

started without deleting any data.

B) New installation

If this is a new system (new installation), press the ESC button once again.

The system now initializes. All the fingers recorded previously on the finger scanner will be

deleted.

4.)

The initialization process runs completely automatically, in the course of which the devices are

connected with each other. This connection is meant to prevent unauthorized people gaining

access in case of an improper finger scanner replacement.

DISPLA Y KEY STROKE DISPLA Y KEY STROKE DISPLA Y KEY STROKE DISPLA Y DISPLA Y

The de vices have now been

initialized. You may sta rt e nrolling

users->

see B:

FINISHED

STA RT

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 40 41

Kommentare zu diesen Handbüchern

Keine Kommentare

EKey Fingerscan Access Control System Betriebsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitskameras EKey Fingerscan Access Control System