EKey Fingerscan Access Control System Bedienungsanleitung PDF herunterladen (Seite 18)

Tips and tricks

Tip 3: Mounting of the control panel

• The control panel switches the lock and is used for programming. Therefore, it has to be mounted in a protected indoor

area, but must still be accessible for programming.

Tip 1: Positionofthemountedngerscanner

• Make sure the nger scanner is freely accessible with the

right and the left hand

• It is important to have enough moving space when

standing in front of the scanner

The use of ekey nger scanners is very easy. Should you experience any problems

nevertheless, please check below written recommendations:

WM (wall-mounted) 135 cm

OM (outlet-mounted) 155 cm recommended

(135 cm vertical*, 110 cm horizontal**)

IN (integra) 155 cm

Finger scanner types Minimum mounting height lower edge

* with in-wall frame OM stainless steel ** IMPORTANT: ensure an easy operability of the nger

Tip 2: Mountingheightofthengerscanner

• The correct mounting height of the nger scanner is critical to facilitate a proper swiping technique

• If the nger scanner is installed too low, you might end up swiping only your ngertip across the sensor providing too little

information to carry out a successful match

• Required mounting heights:

Tip 4: The sensor

• The swipe sensor is integrated into the nger swipe area.

For proper recognition, your full rst nger phalanx must be swiped all the way across this sensor.

• Avoid any mechanical stresses (e.g. scratches with metal objects, etc.) on the sensor!

• In case of dirt or water on the sensor, clean it sideward with a nger or a soft cloth.

Do not use any aggressive cleaning agents or rough sponges for cleaning the sensor.

Tip 5: Finger selection

• The best ngers for swiping tend to be either (1) middle, (2) index or

(3)ringngers

• The thumb and the small nger shall not be used

• Use a nger without any injuries or abrasions. The clearer you can see the nger lines, the better the recognition of a nger

will be.

• If a particular nger does not work properly, try to enroll another one

• Hard physical work may lead to abrasions on index, middle or ring ngers. As a right handed person, try using the small

or ring nger of your left hand and vice versa.

Recommended

nger surface

Sensor

1 2 ... 13 14 15 16 17 18 19 20

Keine Kommentare

EKey Fingerscan Access Control System Bedienungsanleitung Seite 18